WAGNER WALLROLLER TURBOROLL 550 Mode D'emploi page 16

GB
PRIMING THE ROLLER COVER
Risk of crushing by the piston rod.
Do not hold the roller at the piston rod, as the latter moves forward at
the press of a button.
Hold the switch pressed forward (Fig. 12), until paint becomes visible on the paint roll.
Press the switch forward again if necessary.
Do not oversaturate the roller.
During extended break periods (up to 4 hours), wrap your roller cover
i
in a plastic bag to keep it from drying out.
The piston rod can be moved by hand by changing to "MANUAL" (e.g. if
i
the batteries are empty).
CLEANUP
Do not allow battery compartment and motor housing to come into
contact with water or other liquids.
Danger of short-circuits!
Clean the roller only with water (warm and soapy water is recommended).
1. Press the switch back (Fig. 13), in order to suck the paint contained in the roller frame
back into the paint cylinder.
2. Put the TurboRoll 550 with filling valve onto the suction tube and press the switch
forward. This will push the remaining paint back into the paint container. (Fig. 14)
3. Press locking tab and remove roller cover assembly from the arm. (Fig. 15,
a) Insert thumb to first knuckle, pry and pull the cap from the roller cover.
Once the cap is removed, push the roller core out the other end. (Fig. 16, b)
Clean with water.
4. Remove fill tube from the clip and insert it into the fill valve. Set the lever to "MANUAL"
(Fig. 16, a). Submerge fill tube into water. Pull/push plunger 5 times. (Fig. 16, b) Remove
fill tube from the fill valve.
5. Submerge fill valve and roller arm into water. Pull/push plunger 5 times.
Remove the roller arm.
6. Submerge the connecting area and the fill valve into water. Pull/push plunger 5
times.
10
TurboRoll 550