For Your Safety; Hazards And Safety Instructions - Vorwerk THERMOMIX TM6 Manuel D'utilisation

Thermomix®
Risk of electric shock if
water enters appliance.
Risk of an electric
shock from improper
connection to the
power supply.
Risk of an electric
shock if the base unit
or power cord are
damaged.
2

FOR YOUR SAFETY

Safety is an essential part of every Vorwerk product. However, the product
safety of Thermomix® TM6 can only be ensured if this chapter and the warning
notices in the following chapters are followed.
2.1

HAZARDS AND SAFETY INSTRUCTIONS

If water gets into the electrical components, you could get an electric
shock.
• Do not immerse the base unit in water or other liquids.
• Do not hold the base unit under running water.
• Do not pour water over the base unit.
• Disconnect the appliance from the mains power supply before cleaning
the base unit.
• Clean the base unit with a dry or damp cloth only.
• No water or dirt should enter the base unit.
• Do not use Thermomix® TM6 outdoors.
• If water has managed to get into the appliance, contact your Vorwerk
repair service.
An incorrectly installed power connection may cause an electric
shock.
• Only connect the base unit to a plug installed by a qualified specialist.
If the base unit or power cord are damaged, you could get an electric
shock.
• Regularly inspect the base unit, power cord and accessories for possible
damage.
• Ensure that the power cord does not touch hot surfaces or external heat
sources.
• Never use your Thermomix® TM6 if the power cord is damaged.
• Do not use the base unit if it is dropped or damaged in any way.
• In the event of damage to the base unit or the power cord, return your
Thermomix® TM6 to the Vorwerk repair service for examination, repair or
electrical or mechanical adjustment.
• If the power cord on the base unit has been damaged, it must be replaced
by the manufacturer, its repair service or a similarly qualified person to
avoid hazards.
• Never attempt to repair the base unit yourself.
• Never put your fingers into the openings that are intended for the contact
pins on the base of the mixing bowl and do not insert any objects into
these openings.
35
en