Inserting And Removing The Spray Nozzle - Stihl RE 110 Notice D'emploi

English
► If the high-pressure hose is difficult to push into the spray
gun, apply a food-safe fitting grease to the sealing surface
on the high pressure hose.
2
► Attach the spray lance (1) to the spray gun (2).
► Turn the spray lance until it engages.
► If the spray lance hose is difficult to attach to the spray
gun, apply a food-safe fitting grease to the sealing surface
on the spray lance.
8.4.2 Removing the Spray Gun and Lance
WARNING
To reduce the risk of severe injury from high-pressure spray,
always switch off the pressure washer, shut off the water
supply, relieve any remaining pressure in the system and
lock the spray gun trigger before attempting to remove or
disassemble the spray gun or lance.
To remove the spray gun and lance:
► Switch off the pressure washer, @ 10.2.
► Disconnect the pressure washer from the power supply.
► Shut off the water supply.
► Pull the spray gun trigger to relieve pressure.
► Lock the spray gun trigger.
20
1
2
1
► Press the spray lance (1) against the spray gun (2) and
turn until it stops.
► Remove the spray lance (1) from the spray gun (2).
2
1
► Press down and hold the locking lever (1).
► Pull out the high-pressure hose (2).
8.5

Inserting and Removing the Spray Nozzle

8.5.1 Inserting the Spray Nozzle
WARNING
To reduce the risk of severe injury from unintended
spraying, switch off the pressure washer, relieve system
pressure and lock the spray gun trigger before attempting to
adjust or change a spray nozzle or other accessory.
8 Assembling the Pressure Washer
0458-620-8221-A