Fitting, Removing Spray Lance - Stihl RE 98 Notice D'emploi

Holder for high-pressure hose
4
Position the holder (3) for the high-
N
pressure hose between the sides of
the handle frame
Press the plugs (4) through the
N
handle frame into the mounts of the
holder – the plugs must snap into
place and be inserted flush in the
handle frame
RE 98
Holders for power cord
5
3
5
Press the holders (5) for the power
N
cord into the mounts on the housing
4
– holders must snap into place
Connector on water inlet
Attach the connector (6) to the
N
water inlet by hand and tighten it
6
Fitting, removing spray
lance
Spray lance
2
Press the spray lance (1) into the
N
mount on the spray gun (2), turn it
by 90° so that it engages
Remove
Press the spray lance (1) into the
N
mount on the spray gun (2), turn it
by 90° and pull it out of the mount
Nozzle
4
Insert nozzle (3) in spray lance until
N
the safety latch (4) engages – at
which point the safety latch button
will spring out again – the adjustable
high-pressure nozzle has an anti-
twist device; orient this according to
the groove on the spray lance
English
1
3
+
31