Inserting And Removing The Spray Nozzle - Stihl RB 200 Notice D'emploi

1
2
Release the trigger lockout (1)
N
Squeeze the spray gun trigger (2)
N
and wait until a uniform water flow
emerges from the spray lance
Release the spray gun trigger and
N
engage the trigger lockout
NOTICE
Lack of water can damage the high-
pressure pump. Only start the engine
when the water hose is connected and
the water supply is turned on.
RB 200
Inserting and Removing the
Spray Nozzle
Selecting the appropriate spray nozzle
The pressure washer is offered with a
range of high-pressure nozzles that can
be connected to the spray lance.
1
2
3
1 Fan-jet nozzle (yellow) jet angle 15°
Nozzle for removing stubborn dirt.
2 Fan-jet nozzle (green) jet angle 25°
Universal nozzle for cleaning large
surfaces.
3 Low-pressure nozzle (black) jet
angle 65°
Nozzle for use with a detergent.
Use the low-pressure connector
and suction hose to draw detergent
from a detergent container. The
detergent is added to the water in
the high-pressure pump.
Inserting the spray nozzle
WARNING
To reduce the risk of severe laceration
and other personal injury from fluid
injection, shut off the pressure washer,
relieve system pressure and lock the
spray gun trigger before removing,
installing or adjusting any spray nozzle
or accessory.
WARNING
Confirm that the nozzle is fixed securely
in the quick-action coupling. If the high-
pressure nozzle is not secure, it can fly
out of the spray lance during operation
and cause injury.
Shut off the pressure washer and
15°
N
squeeze the spray gun trigger to
relieve system pressure
25°
Lock the spray gun trigger
N
Remove all sand and debris from
N
65°
the connection
2
Pull back the coupling sleeve (1) as
N
far as it will go and hold it there
Push the high-pressure nozzle (2)
N
as far as it will go into the coupling
Push the coupling sleeve forward as
N
far as it will go
Pull the high-pressure nozzle and
N
confirm that it is seated securely
English
1
15