General Information; Buffering (Trickle) Mode; Buffering The Battery - Würth 0510 955 607 Mode D'emploi

Buffering (Trickle) mode

General informa- Buffering (Trickle) mode is intended exclusively for relieving the battery during a vehicle
tion diagnosis or software update. The power used over an extended period of time must be
less than the charger's maximum output current (35 A), otherwise the battery will be
drained. Buffering (Trickle) mode is not suitable for fully charging the battery.
Buffering the bat-
tery
1
3
62
CAUTION! Risk of damage when attempting to charge a faulty battery. Before
buffering, ensure that the battery is fully functional.
Plug in charger mains plug
Select Buffering mode using the up/down keys.
2
Connect battery - the de-energised charger leads mean there are no sparks when
connecting to the battery, even if the charger is already connected to the mains supply.
- Connect the red charger lead to the positive pole (+) on the battery
- Connect the black charger lead to the negative pole (-) on the battery
CAUTION! Risk of damage if the wrong voltage is set. Always ensure that the cor-
rect battery voltage is set.
Set the correct battery voltage using the up/down keys (6 V /
4
12 V / 24 V).
Confirm the selection using the Stop/Start key
5
The charger automatically identifies the
battery, e.g. 12 V, and starts the buffering
process after 5 seconds.
If the battery voltage is not correctly identi-
fied (e.g. in the event of a deeply dischar-
ged battery), you have 5 seconds to enter
the correct battery voltage, as follows: