Start-Up; Safety; Proper Use; Mains Connection - Würth 0510 955 607 Mode D'emploi

Start-up

Safety

Proper use

The charger is designed to charge the batteries listed below. Any use above and beyond
this purpose is deemed improper. The manufacturer shall not be liable for any damage re-
sulting from such improper use. Proper use also includes:
-
-
The following batteries may be charged:
-
-
-

Mains connection

The rating plate, which is located on the housing, contains information about the permitted
mains voltage. The charger is designed for this mains voltage only. The fuse protection re-
quired for the mains lead can be found in the "Technical data" section. If there is no mains
lead or mains plug on your device, fit one that conforms to national standards.
Safety features - The following safety features are provided as standard with the Active Inverter:
standard protec-
-
tive equipment
-
-
-
50
WARNING! Incorrect operation may result in serious injury or damage. Do not
use the functions described here until you have thoroughly read and understood
the following documents:
- Operating instructions
- All the operating instructions for the system components, especially the safe-
ty rules
- Battery and vehicle manufacturers' operating instructions and safety rules
following all the information in the operating instructions
regular checking of the mains and charger leads
WARNING! Charging dry batteries (primary cells) and non-rechargeable batter-
ies can cause serious injury or damage, and is therefore prohibited.
Wet batteries:
sealed batteries with a liquid electrolyte (recognisable by the vent plugs) and low-
maintenance/maintenance-free wet batteries (MF)
AGM batteries:
sealed batteries (VRLA) with immobilised electrolyte (sealant)
Gel batteries:
sealed batteries (VRLA) with immobilised electrolyte (gel)
NOTE! Inadequately dimensioned electrical installations can cause serious dam-
age. The mains lead and its fuse must be dimensioned to suit the local power sup-
ply. The technical data shown on the rating plate applies.
Voltage-free and spark-free terminals protect against explosions
Reverse polarity protection prevents the charger from being damaged or destroyed
Short-circuit protection provides effective protection for the charger. The fuse does not
need to be replaced in the event of a short circuit
A charging time monitor provides effective protection against overcharging and de-
struction of the battery