Interrupting Charging - Würth 0510 955 607 Mode D'emploi

If the selection window for the battery voltage does not open, then the battery is in a state
of extreme deep-discharge (less than 2 V). In this case, it is advisable to use Refresh mode
to reactivate the deep-discharged battery. For more information, see the "Refresh mode"
section.
-
If Charging mode is still required despite the battery being in a state of extreme deep-dis-
charge
-
-
-
8
Interrupting
charging
60
Confirm the selection using the Stop/Start key
6
The relevant warning appears
Acknowledge the OK button in the warning using the Stop/Start key.
Use the up/down keys to select the correct battery voltage in the subsequent selection
window.
Confirm the selection using the Stop/Start key
CAUTION! Risk of sparks if the charger leads are disconnected too soon. Before
disconnecting the charger leads, press the Stop/Start key to finish charging.
To cancel charging:
7
- Press the Stop/Start key
Disconnect the charger
- Disconnect the black charger lead from the negative pole (-) on the battery
- Disconnect the red charger lead from the positive pole (+) on the battery
NOTE! Danger of damage to connection sockets and plugs. Do not disconnect or
unplug charger leads while charging.
Press the Stop/Start key while charging
1
- The process is interrupted
- A set of four bars shows the state of
charge of the battery (e.g. the third bar
represents a state of charge of 80%).
- All four bars are continuously display-
ed.
- The state of charge is 100%.
- The battery is ready to use.
- The battery may remain connected to
the charger for any length of time.
- Conservation charging counteracts
battery self-discharge.