Wall Bracket Option; Preparations For Security Lock; Installation - Würth 0510 955 607 Mode D'emploi

Wall bracket op-
tion
Preparations for
security lock

Installation

The space requirement measurements in mm illustrated below are given to ensure that
there is easy access to the plug connections:
"click"
"click"
NOTE! If the charger is installed in a switch cabinet (or a similar separate area),
then forced-air ventilation must be provided to ensure adequate heat dissipation.
There must be a clearance of 10 cm all around the charger.
The security lock is not contained in the
scope of supply.
A security lock can only be attached
- to the groove on the housing as shown
- to the groove on the housing that is ex-
actly opposite
- using spacer M8 DIN 125 or DIN 134,
located as shown
55