Cub Cadet ZT2 54 Manuel De L'opérateur page 32

2. Use a 15⁄16" wrench to hold the hex nut on top of the
spindle assembly when loosening the hex nut (a) securing
the blade (b). A block of wood (c) may be placed between
the deck housing and the cutting edge of the blade (b) to
help in breaking loose the hex nut (a) securing the blade.
See Figure 49.
(b)
Figure 49
3. When re-installing the blades, be sure they are installed so
that the wings are pointing upward toward the top of
the deck.
4. Tighten the hex nuts (a) to 70-90 ft-lbs (95-122 N-m).
5. Re-install the deck (refer to Deck Installation).
SERVICE AND MAINTENANCE
(c)
(a)
Changing the Transmission Drive Belt
Several components must be removed and special tools used
in order to change the tractor's transmission drive belt. See
your authorized service dealer to have the transmission drive
belt replaced.
Tractor Creeping
Creeping is the slight forward or backward movement of the
tractor when the throttle is on and the speed control levers are
in the neutral position. If your tractor creeps, see an authorized
service dealer.
32