Configuration Mode - Burkert 8041 Manuel Utilisateur

Example of a measured flow velocity visualized by the bargraph:
If the 0-10 m/s measuring range has been chosen, the following bargraph shows a measured flow velocity of
7.2 m/s (7 leds lit and the 8th led flashing twice = 72% of the full scale)
Reading mode
Flow measurement
Press briefly
Relay switching mode *
Press briefly
Relay low switching threshold *
Press briefly
Relay high switching threshold *
Press briefly
Relay switching time-out *
Press briefly
* The device automatically goes back to the reading mode of the flow velocity measurement, if the push-button
is not pressed for 10 s.
8041
CONFIGURATION
0
1 2 3 4 5 6 7 8 910

Configuration mode

Hold
> 2 s
Hold
> 2 s
Hold
> 2 s
Hold
> 2 s
Hold
> 2 s
.....
Push-button
9
100% FS
Flowmeter calibration
Relay programming
Green led blinking
1 up to 5 times
Red led off
Red led lit
Bargraph
Led off
Led lit
Led blinking