This Quick Start diagram shows the different installation and programming steps to be
carried out to ensure the good operation of the appliance.
Select the mains frequency by means of switch 1
Select the current output type (sourcing or sinking)
QUICK START
Unpack the appliance
Order
code OK?
Yes
Unscrew the 4 screws
Select the filtering level by
means of switches 2 and 3
Select the measuring range by
means of switches 4 and 5
Pass the cables through the cable glands
and connect them to the electronic board
Earth the shielding of the power supply
Install the magmeter on the pipe then power it
Calibrate the "zero flow" point
6
Contact your
No
Burkert agent
See 3.2
See 3.3
See 4.4
See 3.5
See 4.4
See 4.3
See 4.1 and 4.2
See 3.4
8041