Modifying The Position Of The; Tips And Recommendations; Questions On The Evb - Slim Receiver For Variation Io - SOMFY EVB Notice Installateur

8.4. Modifying the position of the horizontal slats
(slats not horizontal when the blind rises)
Press the Up and Down buttons for 5 seconds on the
control point: The blind
Press the "my" and Down buttons on the control point:
the blind
pressing the Up or Down button on the control point.
on the "my" and Down buttons on the control point until
the blind moves.
If necessary, it possible to perform this setting in the

9. TIPS AND RECOMMENDATIONS

9.1. Questions on the EVB - Slim receiver for Variation io?

Observations
The blind does not
The wiring is incorrect.
operate.
The motor is in heat protection
mode.
The Somfy io control point battery
is low.
The control point is not compatible.
The Somfy io control point used
has not been programmed into the
actuator.
operate with the EVB - Slim receiver
for Variation io.
simultaneously
Possible causes
© 2013 Somfy SAS. All rights reserved. 02/2013
Solutions
Check the wiring of the EVB - Slim receiver
for Variation io and modify it if necessary.
Wait until the motor cools down.
Check whether the battery is weak and
replace it if necessary.
Check for compatibility and replace the
control point if necessary.
Use a programmed control point or program
this control point.
Check the data sheets to see whether the
motor meets the necessary requirements.