Pre-Programming The Somfy Io Local Control Point; Checking The Motor's Direction Of Rotation; Setting The Time Of Functioning - SOMFY SLIM IO RECEIVER RS+PLUG Notice

Slim io Receiver RS + Plug

4.2. PRE-PROGRAMMING THE SOMFY IO LOCAL CONTROL POINT

• Press the Up and Down buttons simultaneously.
The motorised product moves briefly.
The Somfy local io control point is pre-programmed to the
motor.

4.3. CHECKING THE MOTOR'S DIRECTION OF ROTATION

1) Press the Up button on the control point:
• If the motorised product raises, the direction of rotation is
correct.
• If the motorised product lowers, the direction of rotation is
incorrect:
- Press the "my" button on the control point until the
motorised product moves. The direction of rotation is
modified.
2) Press the Up button on the control point to check the direction
of rotation.

4.4. SETTING THE TIME OF FUNCTIONING

4.4.1. Automatic mode
͉
This mode is not advised when the receiver is used with Nina,
Tahoma, or Connexoon.
1) Check the rotation direction of the motor (see § 4.3).
2) Press the Up and Down buttons simultaneously for at least
5 seconds.
3) Press the "my" button for at least 2 seconds.
The motorised product moves briefly and
Time of functioning T(f) = 4 min.
4) Go to § 4.5.
4.4.2. Manual mode
The time of functioning is measured during the setting.
͉
This mode is used in order to have better precision when the receiver is used with Nina, Tahoma, or
Connexoon.
Attention
The motor must be previously set.
1) Check the rotation direction of the motor (see § 4.3).
2) Press the Up and Down buttons simultaneously for at least
5 seconds.
The motorised product moves briefly and the manual mode is
activated.
3) Press and hold the Up button and let the motorised product
reach its up end limit.
4) Briefly press the Up and Down buttons simultaneously.
The motor goes downward and calculates its Time of
functioning T(f).
Copyright © 2017 SOMFY ACTIVITE SA, Société Anonyme.. All rights reserved.
EN
2 s
5 s
2 s
5 s
25