Checking The Motor's Direction Of Rotation - SOMFY EVB Notice Installateur

6.3. Checking the motor's direction of rotation

Press the Up button on the control point:
a) If the blind raises, the direction of rotation is correct:
b) If the blind lowers, the direction of rotation is incorrect:
press the "my" button on the control point until the blind
Press the Up button on the control point to check the
direction of rotation.
When setting the direction of rotation with an actuator equipped with a non-functional
mushroom in the lowering direction, in order not to risk damaging the blind, it is mandatory to
adjust the upper end limit below the mushroom before using the Slim receiver for Variation io.
6.4. Modifying the end limits (only valid for a blind equipped with a
J4 WT motor)
6.4.1. Modifying the upper end limit
Place the blind in the intermediate position.
Press the Up and Down buttons for 5 seconds on the
control point: the blind
Nothing happens for 5 seconds, then the blind moves
Raise the blind by pressing the Up button.
The blind
the end limit adjustment mode.
Continue to press the Up button until the desired upper
end limit is reached.
Memorise the upper end limit by pressing the Down button.
the end limit adjustment mode and has saved the upper
end limit.
It is mandatory to repeat the linear travel adjustment
procedure after the end limit has been set.
© 2013 Somfy SAS. All rights reserved. 02/2013
Setting the end limits
a =
b
=