Replacing A Lost Or Broken Somfy Io Control Point - SOMFY EVB Notice Installateur

9.1. Questions on the EVB - Slim receiver for Variation io?
Observations
I have a wind sensor
and the blind rises to
The sensor is paired/set.
the upper end limit
regularly or even
every hour
The battery of the Somfy io sunlight
sensor is weak.
Despite the presence
of a wind sensor,
when it is windy, the
blind does not reach
The sensor is not paired/set.
the upper position.
I don't think the
position between the
The linear travel setting is incorrect. Re-set the linear travel.
end limits is accurate
The motor is close to the thermal
limit.
ladders.
operate with the EVB - Slim receiver
for Variation io.
I have overworked my blind outside
the end limits.

9.2. Replacing a lost or broken Somfy io control point

Refer to the corresponding guide.
This reset deletes all control points, all the sensors and all the end limit settings, and
resets the actuator's direction of rotation and favourite position "my".
The linear travel is cleared.
The favourite position of the blind is reset to 700 ms from the lower end limit.
The value of the angular travel is reset to the default value (1200 ms).
The horizontal slat position is reset to 0% of the angular travel.
70
Possible causes
© 2013 Somfy SAS. All rights reserved. 02/2013
Solutions
There is radio interference or the sensor
is out of reach. Position the EVB - Slim
receiver for Variation io outside the head
rail.
Check whether the battery is weak and
replace it if necessary.
Refer to the corresponding guide to pair/set
the sensor.
Wait until the motor cools down.
No solution by adjusting the EVB - Slim
receiver for Variation io. Recall the "my"
position from the lower end limit.
Check the data sheets to see whether the
motor meets the necessary requirements.
Position the blind at one of the end limits
and re-operate the blind.