SOMFY EVB Notice Installateur page 64

6.4.2. Modifying the lower end limit
Place the blind in the intermediate position.
Press the Up and Down buttons for 5 seconds: the blind
Nothing happens for 5 seconds, then the blind moves
Lower the blind by pressing the Down button.
the end limit adjustment mode.
Continue to press the Down button until the desired lower
end limit is reached.
Memorise the lower end limit by pressing the Up button.
the end limit adjustment mode and has saved the lower
end limit.
It is mandatory to repeat the linear travel setting after
the end limit has been adjusted.
6.5. Modifying the linear travel
The linear travel must be set AFTER the actuator end limits have been set.
Before adjusting the linear travel, ensure that the blind is positioned:
- either close to the lower end limit.
- or at the upper end limit.
In the case of a blind that is more than 3 metres high, it is necessary to begin the adjustment
procedure with the blind in the upper end limit or lower end limit position
Press the Up and Down buttons on the control point for
5 seconds: The blind
the Up and Down buttons on the control point
at the same time: The blind performs a complete cycle and
© 2013 Somfy SAS. All rights reserved. 02/2013