Operation; Stop Function; Up And Down Buttons - SOMFY EVB Notice Installateur

6.7.
When using a 2 Way io-homecontrol remote control, it is necessary to press the My button
until the blind
point.
6.7.1. Using a pre-programmed Somfy io local control
point (6.2)
PROG button on this control point:
the blind
6.7.2. After a power cut
Press the Up and Down buttons on the new control point
simultaneously until the blind moves.
PROG button on this control point:
the blind

7. OPERATION

7.1. Standard operation
points: Situo mobile io VB, Easy Sun io, Composio io and Smoove sensitive io "mode 3")
7.1.1. Favourite position (my)
Besides the upper and lower positions, an intermediate position known as the "favourite
position (my)" may be programmed in the motor. The "my" favourite position is pre-set in the
factory, and corresponds to the "slats lowered, sun protection" position.
To modify or delete the favourite position (my), see the section entitled "Modifying settings".
button: the blind starts to move, then stops and angles
the slats in accordance with the angle programmed for the
favourite (my) position.

7.1.2. STOP function

The blind is moving.
"my" button on the control point: the
blind stops automatically.

7.1.3. Up and Down buttons

A brief press on the Up or Down button on the control point
causes the slats of the blind to turn.
A long press on the Up or Down buttons on the control
point will cause the blind to raise or lower completely.
(the operation below is only possible with the following control
"my"
© 2013 Somfy SAS. All rights reserved. 02/2013