Clutch Adjustment - SWM VA'RE:Z125 Manuel - Utilisation - Entretien

THROTTLE CONTROL CABLE ADJUSTMENT
To check proper adjustment of the throttle control
transmission, operate as follows:
turn throttle twistgrip (1) and make sure it has a
-
clearance of approx. 2 mm (0.07 in.);
should this not be the case, move the two protective
-
rubber elements (2);
loosen the lock nuts (3) and act on the adjuster (4) to
-
adjust the clearance;
tighten back the lock nuts (3);
-
reassemble all parts, proceeding in reverse order.
-
WARNING
Using the motorcycle with a damaged
throttle control cable considerably
compromises safe riding.
WARNING
Exhaust gas contains poisonous carbon
monoxide. Never run the engine indoor.
36
EN -

CLUTCH ADJUSTMENT

Normally, the clutch is adjusted by only stretching
the cable using the adjusting unit positioned on the
relevant control assembled on the handlebar. As a rule
it is sufficient to operate on this adjuster to restore
the clearance due to the flexible transmission stretch.
The control lever must always have a free play (C)
(about 3 mm - 0.12 in.) before starting to disengage
the clutch. To adjust this play, loosen the lock nut (2),
operate the adjuster (3) after removing the rubber cap
(1).
The adjustment can also be carried out through the
tensioner (4) on the right side of the engine. If the
clutch slips under load or drags in disengaged position
after play has been adjusted, it must be taken apart
for inspection.
For this operation contact a Dealer.