Program Start; Online/Offline Operating Mode - Moeller DE4-COM-2X Manuel

03/01 AWB823-1279-D/GB/F

Program Start

Online/Offline
Operating Mode
Press the "Start" key.
X
Here you will find the DE4-CFG-200 folder under
"Programs" .The program DE4-CFG-200 is located in this
folder.
Start the DE4-CFG-200 program by clicking on it.
X
The program DE4-CFG-200 has two operating modes. After
starting the program DE4-CFG-200, the program will be in
the online or offline mode.
Online means that the DE4-COM-2X interface can commu-
nicate with the drive controller. This allows data to be trans-
ferred to/from the drive controller through the interface
cable. The online mode can be recognised as follows:
• a tick is shown in front of the menu item
"Communication/Online" ;
• the F4 button in the toolbar is not crossed through.
• the word "Online" is shown in the status line at the
bottom edge of the screen.
This mode mode is necessary when commissioning the drive
controller.
Offline means that there is no connection to the drive
controller. The offline mode can be recognised as follows:
• no tick is shown in front of the menu item
"Communication/Online" .
• the F4 button in the toolbar is crossed through.
• the word "Offline" is shown in the status line at the
bottom edge of the screen.
This operating mode can be useful for pre-configuring the
drive or to document the parameters in the office. In offline
mode, no further hardware is required apart from the PC.
Program Start
GB-29