Construction - Moeller DE4-COM-2X Manuel

03/01 AWB823-1279-D/GB/F

Construction

Figure 2: Layout of the DE4-COM-2X interface module
a 9-pin Sub-D socket for RS 232/RS 485 interface
b Fixing screw
c Plug-in screw terminals for RS485 interface
d Operating state LEDs for the drive controller
e Yellow TxD LED for transmit signal:
FLASHING = interface/drive sending response to PC
f Yellow RxD LED for receive signal:
FLASHING = interface/drive receiving command from PC
g Green Vcc LED for power supply:
ON = interface module DE4-COM-2X and drive controller
connected to power supply.
FLASHING = interface module DE4-COM-2X connected to
power supply, drive controller switched off or not present. Only
applicable for external power supply.
h Plug-in screw terminals for external power supply
(15 to 0 V)
i PE connection for 6.35 mm Fast-On connector,
required cable cross-section min. 2.5 mm²
Construction
GB-7