Spektrum SPMR1010 Manuel D'utilisation page 8

EN
4. The flashing green LED corresponds to the selected channel. When the first LED
is flashing, the throttle channel is selected (Channel 1).
IMPORTANT: Channel 1 will not have a control signal during trim
programming to prevent accidental motor operation. All other channels will
operate during trim programming to enable you to verify the servo directions.
During trim programming, the four green LEDs on the transmitter
will flash to indicate which channel is selected for reversing
Channel 1
Throttle
To reverse the selected channel,
press the right vertical trim up
(Elevator trim for Mode 2). If
you don't want to reverse the
selected channel, proceed to
confirming the direction.
5. Once the first four channels have been confirmed, the LEDs will indicate
channels 5 through 7, along with a series of tones matching the channel
number. Reverse channels as necessary and confirm the setting with the
same process as the previous step.
Channel 5
6. After the last channel is confirmed, power the transmitter OFF to save the
settings and exit trim programming.
8
Channel 2
Elevator
The RGB LED
indicates servo
direction;
green for normal,
red for reverse
Channel 6
Channel 3
Aileron
To confirm the direction for
the selected channel, press
and hold the A button. The
setting will be saved and the
next channel will be selected.
Repeat the process through
the first four channels.
Channel 7
Channel 4
Rudder