Changing The Throttle Ratchet; Adjust Stick Tension - Spektrum SPMR1010 Manuel D'utilisation

EN

Changing the Throttle Ratchet

1. Remove the batteries from the transmitter.
2. Remove the six Phillips head screws that secure the rear transmitter case half.
3. Put the transmitter face down on a piece of foam or a towel and remove the rear case.
NOTICE: Do not pull or disconnect any of the wires attached to the back
transmitter half or damage may result.
4. Locate the silver throttle friction straps (A) on both gimbals. One strap
engages a serrated section on the gimbal for a ratcheted throttle, while the
other strap engages the smooth section on the gimbal.
5. To change the throttle ratchet, loosen the throttle strap so it does not touch the throttle
gimbal. Tighten the opposite throttle strap to engage the desired throttle ratchet.

Adjust Stick Tension

1. Disconnect the battery holder or optional battery from the transmitter and set aside.
2. Remove the six Phillips head screws that secure the rear transmitter case half.
3. Put the transmitter face down on a piece of foam or a towel and remove the rear case.
4. Tighten or loosen the screws (C) a small amount using a small Phillips screwdriver.
NOTICE: Always do a test of stick tension while turning these screws to
ensure stick tension is not too loose or too tight. Tightening a screw too much
can damage a spring. Loosening a screw too much can let a spring fall off
and cause short-circuit in the transmitter.
CAUTION: Always power off the transmitter, disconnect and remove
the battery before adjusting stick tension or friction straps. Not doing
so could result in property damage or injury.
10