Troubleshooting - Spektrum SPMR1010 Manuel D'utilisation

EN
Troubleshooting Guide
Problem Possible Cause
Throttle not at idle and/or throttle trim
Aircraft
too high
will not
respond to
Throttle servo travel is lower than 100%
throttle but
responds
Throttle channel is reversed
to other
controls
Motor disconnected from ESC
Transmitter too near aircraft during
binding process
Aircraft
Aircraft or transmitter is too close to large
will not
metal object, wireless source or another
Bind
transmitter
(during
The bind plug is not installed correctly in
binding)
the bind port
to trans-
Flight battery/transmitter battery charge
mitter
is too low
Bind button not held long enough during
bind process
Transmitter too near aircraft during
connecting process
Aircraft or transmitter is too close to
large metal object, wireless source or
Aircraft
another transmitter
will not
connect
Bind plug left installed in bind port
(after
binding)
Aircraft bound to different model
to trans-
memory.
mitter
Flight battery/Transmitter battery
charge is too low
Transmitter may have been bound
to a different aircraft using different
DSM protocol
Control surface, control horn, linkage
or servo damage
Wire damaged or connections loose
Control
surface
Transmitter is not bound correctly or
does not
the incorrect model was selected
move
Flight battery charge is low
BEC (Battery Elimination Circuit) of the
ESC is damaged
12
Solution
Reset controls with throttle stick and throttle
trim at lowest setting
Make sure throttle servo travel is 100%
or greater
(With battery disconnected from aircraft) Reverse
throttle channel on transmitter
Make sure motor is connected to the ESC
Move powered transmitter a few feet from
aircraft, disconnect and reconnect flight
battery to aircraft
Move aircraft and transmitter to another
location and attempt binding again
Install bind plug in bind port and bind the
aircraft to the transmitter
Replace/recharge batteries
Power off and repeat bind process.
Move powered transmitter a few feet
from aircraft, disconnect and reconnect
flight battery to aircraft
Move aircraft and transmitter to another
location and attempt connecting again
Rebind transmitter to the aircraft and remove
the bind plug before cycling power
Select correct model memory on
transmitter
Replace/recharge batteries
Rebind aircraft to transmitter
Replace or repair damaged parts and
adjust controls
Perform a check of wires and connections,
connect or replace as needed
Rebind or select correct airplanes in
transmitter
Fully recharge flight battery
Replace ESC