Back Panel; Power Supply Module; Pedal Connector; Turnable Voltage Selector - Gima DIATERMO MB200 Mode D'emploi

GIMA SpA

4.11 BACK PANEL

1 Equipotential binding
2 Connector for pedal
3 Voltage selector
4 Mains voltage connector
4.11.1 P S M
OWER UPPLY ODULE
Power supply module is the connection point of mains voltage feeding to the unit. This module is provided with line fuses.
WARNING: before switch on the unit, operator has to verify that requested mains voltage corresponds to the voltage available
from the electrical net.
4.11.2 P C
EDAL ONNECTOR
On the left part of the back panel it is pedal connector.
4.11.3 T V
URNABLE OLTAGE
On the power supply block can be present a voltage selector suitable for the selection of 115V~ or 230V~ mains voltage.
Before powering the unit, it is necessary to preset the correct mains voltage by properly set the voltage selector. The unit is
factory preset to 230V~.
Manuale d'istruzioni / Instruction's Manual
S
ELECTOR
MA182IGBb
DIATERMO MB200
31