Automatic Control Of The Internal Parameters; Connectors - Gima DIATERMO MB200 Mode D'emploi

GIMA SpA DIATERMO MB200
Press the CUT pushbutton to confirm the level. After the sound level confirmation, on the CUT display the message Sbd
appears while on the COAG display is shown the actual amplitude of the steps for power higher the 20. If the step amplitude
output has wished to be changed (from 1 to 5 or viceversa) press the + and – COAG pushbutton.
Press the CUT pushbutton to confirm the chosen data.

4.9 AUTOMATIC CONTROL OF THE INTERNAL PARAMETERS

The unit has an automatic control system of some of the internal parameters. When switched on, the control is indicated on the
display through the message SEL FCh. If there are not errors, the message PAS Sed appears; if there are errors, Err 001
appears. See Guide to the Problems' Solution for further information.

4.10 CONNECTORS

Connector for return plate
This is the point of connection of the return plate or of the bipolar adapter for BIPOLAR function.
Connector for handle
This is the point of connection of electrode handle. In the case of use of handle without finger switch it shall be connected on the
black buckle.
Manuale d'istruzioni / Instruction's Manual MA182IGBb 30