Introduction; Destination Of Use / Sectors Of Application; Standard Composition; General Description - Gima DIATERMO MB200 Mode D'emploi

GIMA SpA

1.1 DESTINATION OF USE / SECTORS OF APPLICATION

The use of HF electro surgical equipment DIATERMO MB200 has reserved to specialized medical personnel. The equipment
has destined to a temporary use, for surgical operations in emergency room or hospital. It has foreseen its use in the monopolar
cut, cut coagulated or coagulation mode or in bipolar cut and coagulation mode.
The equipment is proper for endoscopic operations.
The equipment is conceived for being used in the following sectors:
Recommended
Causalty
Recommended
Endoscopy
Recommended
First Aid
Recommended
Gastroenterology
Usable
General surgery
Recommended
Gynecology
Recommended
Neurosurgery
Usable
Orthopedics
Recommended
Otorhinolaryngology
Usable
Pediatric surgery
Usable
Plastic surgery
Recommended
Pneumology
Recommended
Urology
Recommended
Vascular surgery
Recommended
Vetenary

1.2 STANDARD COMPOSITION

/pcs= STANDARD
code
GMA10100.40A Electrosurgical unit code
00498.04 Bipolar adpter
00404.08 Cable for connection disposable/5365 neutral plate
0210 Blade electrode 7 cm
0230 Ball electrode 7 cm
0220 Needle electrode 7 cm
5365A Steel neutral electrode
F7920 Disposable split neutral electrode
00500.00 Kit of assorted electrodes(10pcs)
F4148 Reusable handle with finger switches
MA182 Manual of instructions
00302.00 Waterproof foot switch

1.3 GENERAL DESCRIPTION

DIATERMO MB200 is an electro-surgical equipment suited to deliver current for monopolar cut, cut coagulated, with different
degrees of coagulation and coagulation or bipolar cut and coagulation.
A total of ten different modes of use and levels of power, can be stored and recalled for the use simply. It is possible to use either
single plate neutral reference electrodes or electrodes with split conductive zone so to watch the stability of the plate to patient
impedance during the surgical intervention.
Control of the units is via front panel keys and display; mains inlet is located on the rear panel.
The units have automatic control systems that, monitoring the internal parameters, signal the possible damages/errors that are
found.
The operational parameters that are used are constantly stored so that, every time the unit is switched on or the operative method
is changed, the last utilized parameters are recalled.
The level of the emission sound can vary; every operator can choose his own level according to the environmental conditions of
working.
The units can work either through holder-handles with or without pushbuttons or through single or double foot switch command.
Moreover, applying a special adapter it is possible the unit connection to bipolar forceps.
Manuale d'istruzioni / Instruction's Manual

1. INTRODUCTION

description
MA182IGBb
DIATERMO
MB200
/1
/1
/1
/3
/3
/3
/1
/2
/1
/1
/1
/1
DIATERMO MB200
21