Connectors And Controls; Label On The Rear Panel; Manufacturer's Identification Data; Technical Data - Gima DIATERMO MB200 Mode D'emploi

GIMA SpA

4.1 LABEL ON THE REAR PANEL

The requirements for the safety of H.F. surgical equipment ask technical data and graphic symbols must be printed on the
cabinet or on at least one of the panels of generator unit to define its features and oversee its condition of work.
4.1.1 M ' I
ANUFACTURER S DENTIFICATION
DIATERMO MB200 HF electrosurgical unit is designed, manufactured and tested by the LED SpA in its own laboratories in
Aprilia (LT) - Italy.
4.1.2 T D
ECHNICAL ATA
Output CUT(Cut):
Output BLEND(Cut coagulated):
Output FORCED(Coagulation):
Output SOFT(Coagulation):
Output BIPOLAR COAG (Coagulation):
Output BIPOLAR CUT (Cut):
MAIN POWER :
INLET POWER:
FUSE:
DUTY - CYCLE:
CLASS:
4.1.3 M G
EANING OF RAPHIC
The meaning of the graphic symbols printed on DIATERMO MB200 's cabinet is the following:
1. Floating Patient's plate: neither at low-frequency nor at high frequency earth connected
2. The equipment is protected against Cardiac Defibrillator discharge.
3. Not Ionising Radiation emitted
4. Read carefully INSTRUCTION MANUAL before to attempt the use of the equipment.
1
Manuale d'istruzioni / Instruction's Manual

4. CONNECTORS AND CONTROLS

D
ATA
200 W - 250 Ω FREQUENCY: 600 kHz
120 W - 200 Ω FREQUENCY: 600 kHz
150 W - 150 Ω FREQUENCY: 600 kHz
90 W - 100 Ω
100 W - 100 Ω FREQUENCY: 600 kHz
120 W - 250 Ω FREQUENCY: 600 kHz
115/230 V~ - 50/60 Hz selectable
350VA
(230V~) 2xT3.15 A (type 5x20) / (115V~) 2xT6.3 A (type 5x20)
10 seconds active /30 seconds pause
I CF
S
YMBOLS
2
MA182IGBb
FREQUENCY: 600 kHz
3
DIATERMO MB200
4
26