Important - GRAUPNER KADETT 2400 Instructions De Montage

Rudder
Landing flaps, take-off:
Landing flaps, landing:
The stated travels should only be considered as a starting point; you may well find it
necessary to adjust them to suit your personal preference.

Important:

When fitting and adjusting the various linkages you should ensure that they move
freely, without binding, are able to move to their full extent - including trim travel - and
are not obstructed mechanically at any point.
When you move the rudder stick to the right, the rudder should also deflect to the
right (left stick: left rudder). Pull the elevator stick back towards you, and the
elevators must both deflect up (stick forward: elevators down).
If you move the aileron stick to the right, the right aileron should rise, the left aileron
fall. When you move the throttle stick forward, the motor should run to the full-throttle
position.
We recommend that you assign the landing flaps to a two-position switch, and
program the correct travel at the transmitter.
Finally - we hope you have many hours of fun and pleasure flying your KADETT
2400.
Yours - the Graupner team
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler
60 mm right, 60 mm left
20 mm down
80 mm down / 10 mm down-elevator trim
38
4/2008