Publicité
Les langues disponibles
Les langues disponibles
Batteries must not be left within reach or in the vicinity of babies or toddlers. If a child
should swallow a battery, call for a doctor or emergency medical assistance without
delay.
Batteries must not be placed in a microwave oven, nor subjected to pressure: the
results may be smoke and fire or worse.
Never attempt to dismantle Li-Po cells. Taking a battery apart can cause internal
short-circuits, which could result in gassing, fire, explosion and other problems.
The electrolyte and electrolytic fumes are injurious to health. Avoid direct contact with
the electrolyte at all costs. If the material gets in your eyes, on your skin or other part
of your body, it is essential to wash the affected area immediately with copious
amounts of clean water. Consult a doctor as soon as possible thereafter.
Batteries installed in a device should always be removed from the apparatus if it is
not to be used again in the immediate future. Always switch off such devices after
use to avoid discharging the cells to a dangerous level. Recharge the batteries in
good time. Store batteries on a non-flammable, heat-resistant and non-conductive
surface. If you allow a Li-Po battery to become deep-discharged, it will inevitably be
ruined, and must not be used again.
IMPORTANT: when the flight battery is exhausted, you must not dispose of it in
•
the household waste. Take the pack to your local battery reclamation centre.
IMPORTANT: when the useful life of the model and the transmitter are over, do
•
not discard them in the domestic rubbish. The electric and electronic components
in particular must be taken to your nearest electrical recycling centre. Ask your
local authority if you are not sure of its location.
During construction
The receiving system components and control surface linkages should be installed at
the appropriate stage of assembly, as described in these instructions, as it may be
very difficult or even impossible to fit them later.
The building instructions
The notes below are intended to explain certain additional points of construction.
You may wish to alter the order of assembly; this should not cause problems, but
please think carefully about the consequences of any change you make.
Bear in mind that tools such as balsa knives, modelling pins, the ends of thin wire etc.
are sharp or pointed, and can cause injury if not handled with due care.
Ensure that children do not have access to tools, adhesives and paints.
When using solvent-based glue be sure to work in a well-ventilated room.
Take waste adhesives and paints to your nearest toxic waste collection point.
An unobstructed work area of generous size is very helpful for all types of modelling
activity.
If you are a beginner to modelling and are not sure about any of the more difficult
processes, ask an experienced modeller for advice and help.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler
31
4/2008
Publicité
