Important - GRAUPNER WILGA 2000 Guide Rapide

the CFRP spar. If you fit the recommended LiPo flight battery, Order No. 7631.3, this
will automatically be correct.
Check that all control surfaces are exactly at centre (neutral) before flying the model
for the first time; adjust the clevises if necessary.
Control surface travels for normal flying
Ailerons
Elevator
Rudder
Flying the WILGA 2000
The motor has sufficient power to enable the model to take off easily from water
when fitted with the floats. This means that normal flying only requires about 1/3 of
full motor power for a realistic airspeed. If you wish, the aeroplane can easily be
controlled using just rudder and elevator; in this case you will find that its rudder
response is slightly softer than its response to the ailerons.
Please allow the motor to cool off after every flight.

Important:

When fitting and adjusting the various linkages you should ensure that they move
freely, without binding, are able to move to their full extent - including trim travel - and
are not obstructed mechanically at any point.
When you move the rudder stick to the right, the rudder should also deflect to the
right (left stick: left rudder). Pull the elevator stick back towards you, and the elevator
must deflect up (stick forward: elevator down). If you move the aileron stick to the
right, the right aileron should rise, the left aileron fall. When you move the throttle
stick forward, the motor should run at full power.
And finally: we all hope you have many hours of pleasure flying your WILGA 2000.
Yours - the Graupner team.
Environnemental Protection Notes
When this product comes to the end of its useful life, you must not dispose of it in the
ordinary domestic waste. The correct method of disposal is to take it to your local
collection point for recycling electrical and electronic equipment. The symbol shown here,
which may be found on the product itself, in the operating instructions or on the packaging,
indicates that this is the case.
Individual markings indicate which materials can be recycled and re-used. You can make an important
contribution to the protection of our common environment by re-using the product, recycling the basic
materials or recycling redundant equipment in other ways.
Remove batteries from your device and dispose of them at your local collection point for batteries.
In case of R/C models, you have to remove electronic parts like servos, receiver, or speed controller
from the product in question, and these parts must be disposed of with a corresponding collection
point for electrical scrap.
If you don't know the location of your nearest disposal centre, please enquire at your local council
office.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler
8 mm up
15 mm up
15 mm left
8 mm down
15 mm down
15 mm right
40
04/2007