MINN KOTA RIPTIDE SE Manuel De L'utilisateur page 7

5. Deploy the motor and remove the motor assembly from the mount by loosening the Steering Tension Knob and opening the
door.
WARNING:
When raising or lowering motor, keep fi ngers clear of all hinge and pivot points and all moving parts.
6. Position the mount again in the stowed position.
7. Temporarily remove the Phillips screws that fasten the motor rest to the mounting bracket and remove the motor rest to
expose the motor mounting hole pattern.
8. Determine the mounting hole pattern you wish to use from the illustration to the
right. Using the mounting holes in the mount as your template, mark the top deck
of the boat with a pencil or an erasable marker.
9. Remove the mount from the deck of the boat and drill the holes that you marked
in the previous step using a 9/32" drill bit and drill. Be careful not to damage any
wiring or critical features that may exist under the surface you are drilling through.
10. Place the mount on the deck of the boat again and verify the hold down strap is
positioned 15 ¾" from the front of the bow mount as shown in the diagram.
11. Fasten the mount to the deck of the boat using the supplied ¼" – 20 X 2" bolts,
washers and nuts. Tighten the stainless mount hardware securely but slowly
to the deck of the boat using a 7/16" box end wrench. Tightening the stainless
hardware too fast may result in galling and or seizing of the bolts and nuts.
12. Reinstall the motor rest using the six original ¼" Phillips screws.
13. Reinstall the motor assembly into the mount and securely tighten the steering
tension knob.
©2014 Johnson Outdoors Marine Electronics, Inc.
Motor Rest
Mount InstallatIon
Adjustable Depth Collar
Steering Tension Knob
Motor Assembly
15 3/4"
minnkotamotors.com | 7