Assembly - Shindaiwa F220 Manuel D'utilisation

Assembly of the Handle
Socket-head
Cap Screws
Outer Tube
Barrier Bar
Nuts
Assembly of the Handle
Handlebar C220
1. Position the handle over the handle
label on the outer tube. Make sure the
throttle lever is on the right-hand side of
the outer tube.
2. Attach the handle mounting bracket
using the two socket-head cap screws,
washers, and lock washers. At this time,
ONLY finger tighten the screws.
3. Locate the handle about 5 inches ahead
of the shoulder strap hanger or at the
best position for operator comfort.
IMPORTANT!
Regardless of handlebar location, the
aluminum collar must remain in position
between the handlebar and the outer
tube. If the collar is omitted or is improp-
erly installed, the handlebar bracket can
not be properly secured.
4. Using the hex wrench, securely tighten
the two handlebar cap screws.
5. Route the ribbed throttle cable tube
along the handlebar and outer tube.
Install the protector sleeve on the outer
tube.
Handle
Throttle

Assembly

26005
Handle Positioning Label
Spacer
Socket Head
Cap Screws
Handle T220
1. Put 4 square nuts in the frame of
barrier.
2. Fit the handle and barrier over the
outer tube and tighten four bolts.
Tighten four bolts in diagonal fashion for
protection of the handle.
Adjust the handle to the best position for
operator comfort.
Handle Positioning Label
Spacer
Lower Cap
NOTE:
NOTE:
Handlebar
27009B
7