Throttle Cable Adjustment - Shindaiwa F220 Manuel D'utilisation

Throttle Cable Adjustment

1. Hook the end of the throttle cable to the
carburetor.
2. Place the throttle cable in the fan cover
slot and tighten (finger tight only) the
nuts so that the nuts are on either side
of the slot.
Jam Nuts
JAM NUTS
8
3. Adjust the nuts so that the free play of
trigger lever becomes 4~6 mm and then
tighten the nuts securely.
F220/T220
Free Play
4 ~ 6 mm
C220
Free Play
4 ~ 6 mm
4. Fix the earth wire (black) to the fan
cover using the bolt below the fan cover
platform which holds the throttle cable.
5. Connect the switch and wire to the red
wire from the engine.
(RED)
(Red)
IGNITION WIRE
(Black)
Ignition Wire
(BLACK)
Ground Wire GROUND WIRE