Assembly Of The Handle - Shindaiwa F220 Manuel D'utilisation

Outer Tube Assembly
Before Assembling the Outer Tube
1. Using the hex wrench, Loosen the joint
bolt.
Tube Clamp
Hex
Wrench

Assembly of the Handle

Handle F220
1. Position the front handle on the outer
pipe where the "Handle Label" is placed.
2. Press the handle on the outer pipe gen-
tly so that the handle stays as shown.
3. Tighten two 30 mm screws on upper
and two 45 mm screws on lower on the
handle with nuts.
WARNING!
NEVER operate this machine without
the front handle. Operating without
the front handle may result in serious
injury.
NOTE:
The screws and nuts are packed in the tool bag.
6
Assembly of the Outer Tube
1. Slip the outer tube into the joint until
the tube bottoms. The outer tube or
gear case shaft may have to be rotated
slightly for the splines on the main shaft
to fully engage to the engine.
2. Tighten the joint bolt securely using the
hex wrench.
Screw(s) 30 mm
Screw(s) 45 mm
Handle Positioning Label
Joint Bolt
Outer Tube
Front Handle
Nut