Fuel Filter Maintenance - Shindaiwa F220 Manuel D'utilisation

50 Hour Maintenance
Ever y 50 hours of operation (more
frequently in dusty or dirty conditions):
n Remove and clean the cylinder cover
and clean grass and dirt from the cylin-
der fins.
Gearcase Lubrication
F220
Apply new grease to the flexible shaft.
1. Disassemble the shaft case from the
outer tube.
Outer Tube
2. Disconnect the throttle wire and the
other wires, and disassemble the outer
pipe from the engine.
3. Take the flexible shaft out and apply new
grease evenly on the shaft.
Flexible Shaft
4. Reassemble.

Fuel Filter Maintenance

n Use a hooked wire to extract the fuel
filter from inside the fuel tank. Inspect
the fuel filter element for signs of
contamination. If it shows signs of con-
tamination from debris, replace it with
a genuine Shindaiwa replacement fuel
filter element. Before reinstalling the fil-
ter, inspect the fuel line. If you discover
damage or deterioration, the unit should
be removed from service until it can be
inspected by a Shindaiwa-trained service
technician.
18
T220/C220
1. To perform this operation, first remove
the gearcase and debris shield from the
outer tube as follows.
n Remove the index bolt from the
gearcase.
CAUTION!
Do not remove the D-shaped shim
washer! The shim washer prevents
damage from overtightening the tube
clamp screw.
Shims
Shaft Case
Index Bolt
Filter Element
Outer Tube
4 Socket
Head Screws
Clamp Screw
Old
New
Grease
Grease
Grease Plug
Hooked
Wire
n Loosen the gearcase clamp screw.
n Loosen the four socket head cap screws
that secure the cutting attachment
shield.
n Slide the gearcase and cutting attach-
ment shield off the tube. (Do not lose
the two shims).
2. Remove the filler plug and press new
grease into the gearcase until old grease
is purged from the gearcase, which can
be seen in the outer tube cavity.
3. Clean up the excess grease and reinstall
the cutting attachment shield, two shims
and the gearcase.
4 Socket
Head Screws
Outer Tube
Cavity
CAUTION!
Make sure you do not pierce the fuel
line with the end of the hooked wire.
The line is delicate and can be dam-
aged easily.
Old
Grease