Shindaiwa F220 Manuel D'utilisation page 9

Cutting Attachment Shield Assembly
WARNING!
NEVER operate this machine without
the cutting attachment shield. Operating
without the cutting attachment shield may
result in serious injury.
WARNING!
Carefully inspect the cutting attachment
shield assembly to make sure it is tight-
ened securely and does not wobble.
F220
1. Place the cutting attachment shield
under the triangular flange.
2. Tighten 3 screws (16 mm).
NOTE:
The 3 screws (16 mm) are in the tool
F220
Cutting
Attachment
Shield
Screw 16 mm
To Change Position of Line Cutter.
The line cutter can be positioned in
2 positions to obtain different line length
for cutting.
1. Remove the 2 hex screws with a 4 mm
hex wrench.
2. Rotate line cutter.
3. Reinstall the two hex screws and tighten
them securely.
Socket-head
Cap Screws
Bracket
Shim
Install the Cutting Attachment
Shield C220/T220.
1. Insert the cutting attachment shield
between the outer tube and the cutting
bag.
attachment shield mounting plate.
It may be necessary to loosen the retaining
Flange
nut and clamp screw to adjust cutting attach-
ment shield mounting plate.
2. Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head cap screws.
3. Tighten the four socket-head cap screws
to secure the cutting attachment shield.
CAUTION!
Make sure the clamp screw and retain-
ing nut are securely tightened before
tightening the four socket-head cap
screws.
The line cutter is very sharp. Wear
gloves to protect your hands when
handling.
Be careful to not lose the 2 nuts in the cutting
attachment shield, they are not captured.
Outer Tube
Shim
Nut
Cutting Attachment
Shield Mounting
Plate
NOTE:
WARNING!
NOTE:
T220/C220
Cutting Attachment Shield
Line Cutter
Hex
Screws
Sub-Shield.
(when trimmer head is in use)
1. Attach the shield extension to the
cutting attachment shield.
WARNING!
NEVER use this machine without sub-
shield when using a trimmer head.
Cutting Attachment Shield
Hook
Receiver
Sub-shield
CAUTION!
Make sure the sub-shield is completely
hooked at the hook receiver.
Hook
9