Before You Start; Assembly - Shindaiwa T350 Manuel D'utilisation

Assembly

Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
IMPORTANT
The terms "left", "left-hand", and "LH"; "right", "right-hand", and "RH"; "front" and "rear" refer to directions as viewed by the op-
erator during normal operation.
Assembly of the handle
Install the handle so that it does not hide any of the safety decals.
1. Square nut
2. Barrier
3. Handle
1. Handlebar
2. Handle bracket
3. Handle label
4. Strap hanger
WARNING
CAUTION
4. About 250 mm
5. Bolt
5. Lower Cap
6. Bolt
7. Throttle grip

Before you start

Before you start
Loop handle version
1. Put the 4 square nuts into the frame of barrier.
2. Fit the handle and barrier over the outer pipe and tighten the
4 bolts.
3. Position the handle about 250 mm ahead of the throttle
housing end.
4. Secure the handle by alternately tightening the four bolts in
a diagonal or "crisscross" fashion.
U-handle
1. Loosen the two bolts of the lower cap and remove the lower
cap.
2. Position the handle bracket against the handle label located
on the outer tube.
3. Attach the lower cap with the two bolts and tighten the bolts.
Make sure the front handle is in position per the illustration.
15