Assembly - Shindaiwa C2510/EVC Manuel D'utilisation

Assembly

This unit comes fully assembled with the
exception of the cutting attachment shield
and cutting attachment.
IMPORTANT!
The terms "left", "left-hand", and "LH";
"right", "right-hand", and "RH"; "front" and
"rear" refer to directions as viewed by the
operator during normal operation.
Handlebar C unit
Install the handlebar:
1. Use the 4 mm hex wrench to remove the
lower cap retaining screws from the
handlebar bracket. Remove the cap
from the bracket.
2. Position the handle on the outer tube for-
ward of Handle Positioning Label as
shown. Reassemble the lower cap to the
handlebar bracket in the reverse order
of disassembly.
3. Locate the handle in the best position for
operator comfort.
4. Firmly tighten both lower cap retaining
screws.
5. Secure the cable to the outer pipe with the
2 bands as the illustration shows. The 2
bands are in the tool bag.
6
All manuals and user guides at all-guides.com
This unit comes fully assembled with the
exception of the cutting attachment shield
and cutting attachment.
Prior to Assembly
Before assembling, make sure you have all
the components required for a complete
unit and inspect unit and components for
any damage.
Handlebar and Throttle assembly
Throttle
trigger
Handle positioning
label
Mounting the brushcutter handlebar
Engine and shaft assembly
Cutting attachment shield
Cutting attachment
Kit containing cutting attachment
shield, mounting bracket and hardware,
this owner's/operator's manual and tool
kit for routine maintenance. Tool kits
vary by model and may include a spark
plug/screwdriver combination wrench,
and a scraper.
Ignition switch
Handlebar
Outer tube
Lower cap
retaining
screws
Hanger
Bands