Electrical Safety - PRO-POINT 30A PRO CUT 30 Mode D'emploi

8784639
3. Do not allow people, mobile equipment or vehicles to pass
over the unprotected air hose. Position the air hose away from
high traffic areas, in a reinforced conduit or place planks on
both sides of the air hose to create a protective trench.
4. Prevent damage to the air hose by observing the following:
4.1 Never carry the tool by the air hose.
4.2 Keep the air hose behind the tool and out of the tool's
work path.
4.3 Keep the air hose away from heat, oil, sharp edges or
moving parts.
4.4 Do not wrap the air hose around the tool as sharp
edges may pierce or crack the air hose. Coil the air
hose when storing.
5. A damaged or disconnected air hose under pressure may
whip around and inflict personal injury or damage the work
area. Secure the compressor's air hose to a fixed or
permanent structure with clamps or cable ties.
6. Install an in-line shutoff valve or regulator to allow
immediate control over the air supply in an emergency,
even if a hose is ruptured
7. Check the manufacturer's maximum pressure rating for air
tools and accessories. Compressor outlet pressure must be
regulated so as to never exceed the maximum pressure
rating of the tool.

ELECTRICAL SAFETY

WARNING! Do not touch or handle a live tool with any part
of your body that is wet or damp. Wet skin reduces
resistance to electrical current, increasing the danger of a
serious or fatal shock.
WARNING! To reduce risk of electric shock, be certain that the
plug is connected to a properly
14
30A PRO CUT 30 PLASMA CUTTER
For technical questions call 1-800-665-8685
grounded receptacle.
V1.0