PRO-POINT 30A PRO CUT 30 Mode D'emploi page 13

V1.0
3.4 Ventilation methods that remove gas and fumes from
the welding point before they reach the welder's face
should be given preference.
4. Avoid welding in a work area that has vapours from cleaning,
degreasing or any spraying operations. The heat and light
from welding can react with the vapour and form irritating or
potentially toxic gases. Wait for the vapours to disperse.
5. Consult the manufacturer's Safety Data Sheets (SDS) for
instructions and precautions about metals, consumables,
coatings, cleaners and degreasers.
5.1 Do not weld on coated metals such as galvanized, lead
or cadmium plated steel, unless the coating is removed
from the weld area. The coatings and any metals
containing these elements can give off toxic fumes
during the welding process.
5.2 Do not weld, cut or heat lead, zinc, cadmium, mercury,
beryllium or similar metals without seeking professional
advice and inspection of the welding area's ventilation.
These metals produce extreme toxic fumes, which can
cause discomfort, illness and death.
5.3 Do not weld or cut near chlorinated solvents or in areas
that chlorinates solvents can enter. The heat or
ultraviolet light of the arc can separate chlorinated
hydrocarbons into a toxic gas (phosgene) that can
poison or suffocate the user or bystanders.
AIR TOOL PRECAUTIONS
1. Extended exposure to air tool noise may cause hearing loss.
Ear protection gear can reduce or eliminate the noise level.
2. Inspect the tool's air hose for cracks, fraying or other
faults before each use. Discontinue use if the air hose is
damaged or hissing is heard from the air hose or
connectors, while operating the tool. Replace the
defective component/air hose.
Visit www.princessauto.com for more information
30A PRO CUT 30 PLASMA CUTTER 8784639
13