Personal Safety - PRO-POINT 30A PRO CUT 30 Mode D'emploi

V1.0

PERSONAL SAFETY

WARNING! Wear personal protective equipment approved by
the Canadian Standards Association (CSA) or American
National Standards Institute (ANSI).
HEAD PROTECTION
DANGER! Never look directly at the welding arc without the
proper protection. The light can cause flash burn damage and
impair vision. Although treatment is possible, multiple
occurrences can result in permanent eye damage.
1. Protect your eyes from welding light by wearing a welder's
helmet fitted with a filter shade suitable for the type of
welding you are doing. The welding process produces
intense white light, infrared and ultraviolet light, these arc
rays can burn both eyes and skin.
1.1. Consult the Welding Shade Guide in Appendix A for
the minimum shade to protect the eyes based on the
amperage and type of welding.
2. An opaque helmet will protect against the ultraviolet or
infrared light. A helmet will also protect against ejected hot
material and slag. The helmet should protect the face,
forehead, ears and neck.
3. Wear a fire-resistant head covering like a skull cap or
balaclava hood to protect your head when the faceplate is
down or when using a welding hand-held face shield.
4. Wear ventilated safety goggles beneath the welding helmet
or behind the hand-held face shield. The cooling weld bead
may fragment or eject slag that can damage the eyes,
when the helmet or hand-held face shield is not in place.
4.1 Eye protection equipment should comply with CSA
Z94.3-07 or ANSI Z87.1 standards based on the type of
work performed.
5. Wear fire resistant ear plugs when welding overhead to
prevent spatter or slag from falling into ear.
Visit www.princessauto.com for more information
30A PRO CUT 30 PLASMA CUTTER 8784639
5