Duty Cycle; Thermal Overload Protection; Care & Maintenance - PRO-POINT 30A PRO CUT 30 Mode D'emploi

V1.0

DUTY CYCLE

The cutting unit's duty cycle rating defines how long the
operator can cut before allowing the cutting unit to cool. The
duty cycle is a percentage of a 10 minute period. The cutting
unit must cool for the remainder of the cycle. This cutting unit
has a duty cycle rating of 35% at the rated output (see
Specifications). This means that the user can cut for 3-1/2
minutes and then rest the plasma cutter for 6-1/2 minutes
before using it again.

THERMAL OVERLOAD PROTECTION

An internal thermal protector disconnects the electrical
contacts when the motor draws too much current and
overheats, forcing it to shut down before it is damaged. The fan
remains on to cool the unit. The overload light is lit while cooling.
You may resume welding once the light is off.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace
damaged or worn components. Only use identical
replacement parts when servicing.
3. Follow instructions for changing accessories.
4. Only use accessories intended for use with this tool.
5. Maintain the tool's labels and name plates. These carry
important information. If unreadable or missing, contact
Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
Visit www.princessauto.com for more information
30A PRO CUT 30 PLASMA CUTTER 8784639
25