Assembly & Installation - PRO-POINT 30A PRO CUT 30 Mode D'emploi

8784639
IDENTIFICATION KEY
A Handle
B Power LED
C Overload LED
D Amperage Dial
E Earth Socket (+)
F Torch Socket (-)
G Air Regulator
H Air Vent
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included
Identification Key. Dashed numbers in parenthesis (Fig. 1-1)
refer to a specific point in an illustration or image.
1. Connect the work clamp lead to the earth socket (E) and
tighten by hand.
2. The torch (I) is directly connected to the torch socket (F)
and does not require installation.
INSTALL THE AIR SOURCE
The plasma cutter uses compressed air with the plasma arc to
create an ionized cutting arc. A compressor is the best choice
to provide air, but a cylinder of compressed air may be an
option when a compressor is not available. The cutter's working
pressure range is 65 to 75 PSI.
20
30A PRO CUT 30 PLASMA CUTTER
For technical questions call 1-800-665-8685
I Torch and Cable
J Power Switch
K Power Supply Cord
L Fan
M Pressure Gauge
N Air Connection
O Regulator Drain Chamber
V1.0
Fig. 1