Hazard Definitions - PRO-POINT 30A PRO CUT 30 Mode D'emploi

V1.0
CUTTING OUTPUT
U1 115VAC
U0 325V
U1 230VAC
U0 325V
INTRODUCTION
The Pro Cut 30 Plasma Cutter is a portable, high-efficiency
plasma cutter ideal for cutting conductive metal in either
1/4 in. clean cuts or 1/2 in. sever cuts. The cutter features dual-
voltage sensing technology that allow the unit to plug into
any power supply with the included adapter. It also has
thermal overload protection.
SAFETY
WARNING! Read and understand all instructions before using
this tool. The operator must follow basic precautions to reduce
the risk of personal injury and/or damage to the equipment.
Keep this manual for safety warnings, precautions, operating or
inspection and maintenance instructions.

HAZARD DEFINITIONS

Please familiarize yourself with the hazard notices found in this
manual. A notice is an alert that there is a possibility of property
damage, injury or death if certain instructions are not followed.
DANGER! This notice indicates an immediate and specific
hazard that will result in severe personal injury or death if the
proper precautions are not taken.
WARNING! This notice indicates a specific hazard or unsafe
practice that could result in severe personal injury or death if
the proper precautions are not taken.
Visit www.princessauto.com for more information
30A PRO CUT 30 PLASMA CUTTER
X 35% 60%
I2 30A 23A
U2 92V 89.2V
X 35% 60%
I2 30A 23A
U2 92V 89.2V
100% Definitions
X = Duty cycle Percentage
20A
I2 = Rated Welding Current
88V
U2 = Secondary Voltage
100%
with Welding Current I2
20A
88V
8784639
3