Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
3.
Keep the welding power source and cables as far away
from the user as practical. A minimum of 24 in. is
recommended.
4. Connect the workpiece clamp as close to the weld as
possible, but lay the electrode and workpiece cables away
from the user.
5.
Use the lowest current setting possible during welding.
6.
Avoid long and regular bursts of energy while welding.
Apply the electrode in short strokes and intermittently. This
will prevent the pacemaker from interpreting the signal as a
rapid heartbeat.
7.
Do not allow the electrode to touch the metal while welding.
8.
Keep the lead cable and ground cables on the same side of
your body.
9.
Do not weld while carrying the welding power source.
10. Do not work next to, sit or lean on the welding power source.
UNPACKING
WARNING! Do not operate the tool if any part is missing.
Replace the missing part before operating. Failure to do so
could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect
for damage. Make sure that all items in the contents are included.
Contents:
• Plasma Cutter Unit
• Ground Clamp and Cable • Stand Off Guide
• 115/230V Adapter
Visit www.princessauto.com for more information
30A PRO CUT 30 PLASMA CUTTER
• TRF-45 Cutting Torch and Cable
• Electrode
8784639
• Nozzle
19
Publicité
Table des Matières
