PRO-POINT 30A PRO CUT 30 Mode D'emploi page 16

8784639
the deterioration of protective insulation and create a
shock hazard.
9. Unplug the plasma cutter when not in use as the unit as
current is still entering the unit, even when it is turned off.
10. Frequently inspect input power cable for wear and tear,
replace the cable immediately if damaged. Bare wiring is
dangerous and can kill.
11. Do not use damaged, under sized or badly joined cables.
12. Do not disconnect the power cord in place of using the
ON/OFF switch on the tool. This will prevent an accidental
startup when the power cord is plugged into the power supply.
12.1 In the event of a power failure, turn off the machine as
soon as the power is interrupted. The possibility of
accidental injury could occur, if the power returns and
the unit is not switched off.
13. Make certain the power source conforms to requirements
of your equipment (see Specifications).
POWER TOOL PRECAUTIONS
This equipment requires a dedicated 115/230 volt, 20 amp
single-phase alternating current circuit equipped with a
similarly rated circuit breaker or slow blow fuse. Do not run
other appliances, lights, tools or equipment on the circuit while
operating this plasma cutter.
1. Do not use a power tool with a broken or inoperative
trigger/power switch or safety guard.
2. Make sure the power switch is in the OFF position before
connecting the tool to the power supply.
3. Do not drape or carry coiled welding cables on your body
when the cables are plugged into the plasma cutter.
4. Do not start the tool when the electrode is touching the
workpiece.
16
30A PRO CUT 30 PLASMA CUTTER
For technical questions call 1-800-665-8685
V1.0