PRO-POINT 30A PRO CUT 30 Mode D'emploi page 9

V1.0
8. Do not use the plasma cutter if personal movement is
confined or if there is a danger of falling.
9. Keep all panels and covers securely in place when
operating the plasma cutter.
10. Insulate the ground clamp when not connected to a
workpiece to prevent contact with any metal object.
11. Do not operate the plasma cutter if the torch, welding
cable or ground cable are wet. Do not immerse them in
water. These components and the plasma cutter must be
completely dry before attempting to use them.
12. Do not point the torch or electrode holder at any body part
of yourself or at anyone else.
13. Insulate yourself from the work and the ground using dry
insulation. Make certain that the insulation is large enough
to cover your full area of physical contact.
14. Maintain good ventilation of the louvers on this equipment.
Good ventilation is of critical importance for the normal
performance and service life of this equipment.
15. When working above floor level, use a safety belt to
protect yourself from a fall should you get a shock.
16. The torch is electrically 'hot' when the plasma cutter is
turned on.
FIRE AND EXPLOSION PRECAUTIONS
Welding can produce sparks, hot slag or spatter, molten metal
drops and hot metal parts that can start fires.
1. Clear the floor and walls of an area of all combustible
and/or flammable materials up to 39 ft (12 metres) away
from the plasma cutter. Hot debris ejected during welding
can land at a considerable distance away. Solid floors of
concrete or masonry is the preferred working surface.
Visit www.princessauto.com for more information
30A PRO CUT 30 PLASMA CUTTER 8784639
9