SOMFY Oximo 40 io Notice page 28

EN
Setting the end limits in semi-automatic mode (2.3.3.c)
Setting the upper automatic and lower manual end limits.
1) Lower the motorised product to the desired position by
pressing the Down button.
2) Press the my and Up buttons simultaneously until the
motorised product rises; the lower end limit is set.
3) Press the my button to stop the motorised product.
4) To confirm the end limits, press the my button until the
motorised product moves up and down.
Setting the upper manual and lower automatic end limits.
1) Raise the motorised product to the desired position by
pressing the Up button.
2) Press the my and Down buttons simultaneously until the
motorised product is lowered; the upper end limit is set.
3) Press the my button to stop the motorised product.
4) To confirm the end limits, press the my button until the
motorised product moves up and down.
2.3.4. Recording the control point
The motorisation is in programming mode:
- Quickly press the PROG button on the RTS control point to
be programmed:
→The motorised product moves up and down: this RTS
control point is programmed in the motorisation.
If the motorisation is no longer in programming mode, repeat Step 2.3.1 then perform
Step 2.3.4.
6
Images not contractually binding
1
3
1
3
PROG.
Copyright © 2016 Somfy SAS. All rights reserved
2
4
2
4