Installing Accessories; Standards And Guidelines - THERMOBILE Bio Energy - US Manuel De L'utilisateur

9

INSTALLING ACCESSORIES

9.1 Flue (Fig. 9)
The heater has a flue stack connection.
1. Push a T-piece (A) directly over the
connection (B).
2. Push the flue pipe (C) on the T-piece.
3. Use three screws to screw the flue pipe to the
T-piece.
Caution
The flue must meet the following
requirements.
• The flue must be pointed upwards.
• The flue (or any part of it) may not be
positioned horizontally. A 45° angle is
acceptable.
• It is not allowed to lenghten the flue
connection horizontally.
• When a pipe is used under 45°, pipe pieces
of at least 3.2 ft must be fitted in front of and
at the back of the slanting pipe.
• The flue must stick out at least 1.6 ft above
the apex of the building.
• Keep the vertical part at the back of the
heater as long as possible before leading it
outside through the wall.
4. Fit the following pipe pieces.
5. Place a cap (D) at the end of the flue.
Bio Energy - US
9.2
/i
Bio Energy 2
6 inch
10
For the standards and guidelines, go to
www.thermobile.nl.
40.020.952 - rev. 04 - 2011
Diameter flue

STANDARDS AND GUIDELINES

English
51